Check the fit
Use only on a tank span within 15–25.5 inches and recheck both rim supports after moving equipment.
AQUAPONICS · QUICK START
Install your clear three-cup plant shelf, adjust it to your aquarium and give plant roots direct access to the water.
No suction cups
START HERE
Extend the shelf only until both rim supports sit flat and secure.
FOLLOW ALONG
Rinse the clear shelf and all three plant cups with clean water. Do not use soap or household cleaners around your aquarium.
Lower one cup into each round opening. Check that every rim sits evenly on the shelf and the slotted sides face down.
Place one support over the first aquarium rim, then slide the telescoping section outward until the opposite support reaches the other rim.
Center the shelf and make sure both supports are fully seated. The shelf should stay level without rocking or pressing against equipment.
Guide clean roots through the cup slots and into the aquarium water. Keep leaves and the plant crown above the waterline.
SEE IT IN USE
The adjustable shelf spans 15–25.5 inch aquariums and holds three plants above the tank while their roots remain in the water.
BETTER RESULTS
Use only on a tank span within 15–25.5 inches and recheck both rim supports after moving equipment.
Roots can stay in the water, but the plant crown and leaves should remain above the waterline.
Remove algae with aquarium-safe water and a soft cloth. Avoid abrasives that can scratch clear surfaces.
COMMON QUESTIONS
The telescoping shelf adjusts from 15 to 25.5 inches (about 38 to 65 cm). Measure the exact rim-to-rim span where you plan to install it.
The shelf includes three removable cups, each approximately 2.2 inches (5.5 cm) in diameter.
No. For common water-propagated houseplants, place the cleaned roots in the water while keeping stems, crowns and leaves above the waterline.
Avoid soap and household cleaners. Use aquarium-safe water and a soft cloth, then rinse thoroughly before reinstalling.